connecting Fritz!Card USB v2.1 possible?

Discussion in 'Gateways' started by fabianus, Jul 1, 2010.

  1. fabianus

    Joined:
    Nov 8, 2007
    Messages:
    106
    Likes Received:
    0
    Hello all !

    I would like to know if it is possible to connect a Fritz!Card USB v2.1 to elastix. Does the hardware recognition automatically detect it ? If not, is there any paper on how to get it work?

    Thanks a lot for any feedback !

    Best regards,
    Fabianus
     
  2. fmvillares

    Joined:
    Sep 8, 2007
    Messages:
    1,785
    Likes Received:
    0
    fritz box systems are embedded linux in a beautiful red and white box so...if the usb stick is a valid wifi card and the kernel you have in your linux box and drivers support you config all is possible....but no ootb support likely...you have to configure manually ....(wpa supplicant for shared key, kernel driver etc)...

    best regards
     
  3. fabianus

    Joined:
    Nov 8, 2007
    Messages:
    106
    Likes Received:
    0
    Hello fmvillares,

    thanks a lot for your feedback !

    In fact I have a fritz!card, not a fritz!box. It is an ISDN-Controller.
    Do you have any idea where I could get a "how to" for connecting this divice in order to connect my asterisk (elastix distro) to the telco?

    Best regards,
    Fabianus
     
  4. fmvillares

    Joined:
    Sep 8, 2007
    Messages:
    1,785
    Likes Received:
    0
    you have to look for the manual and the manufacturer drivers and seek for an asterisk driver for it....or a dahdi compatible stack or fix....
    best regards
     

Share This Page