Configuring Elastix + Digium TE220 for T1 line

Discussion in 'General' started by ommxyz, Jan 31, 2010.

  1. ommxyz

    Joined:
    Jun 1, 2009
    Messages:
    2
    Likes Received:
    0
    I need some help on configuring elastix with Digium TE220 .
    Up to now I got Elastix installed in a server with Digium TE220 .
    After following user manual with the card, I got the green light with T1 line (NTT Japan) but
    all channed were shown in use from Elastix GUI, also I could not make outbound call via T1 line.

    Any idea?
     
  2. Megabyte

    Joined:
    Mar 28, 2009
    Messages:
    327
    Likes Received:
    0
    First you have to tell us the signalling and the coding of your digital circuit, is an isdn-pri?

    Those values you can get it from your provider
     
  3. ommxyz

    Joined:
    Jun 1, 2009
    Messages:
    2
    Likes Received:
    0
    I have isdn pri line here. From the data I've collected the signaling is ESF and coding B8ZS,
    now elastix can get only 1 inbound call at a time (I know I have 23 channels).
    Still I can't do any outbound calls even though I've already outbound route
     

Share This Page