channels group in zapata-channels.conf

Discussion in 'General' started by just4fun, Dec 8, 2008.

  1. just4fun

    Joined:
    Dec 8, 2008
    Messages:
    17
    Likes Received:
    0
    Hello!
    Please let me now how to use the floating group number - group=0,11?
    To which group correspond the channels from 1-15,17-31 ? zero or what?
    And to which group correspond the channels from 32-46,48-62?

    The reason of asking such questions is my fault to get outbound calls working.

    Best Regards,
    Andrew Yashchuk

    zapata-channels.conf
    ; Autogenerated by /usr/local/sbin/genzaptelconf -- do not hand edit
    ; Zaptel Channels Configurations (zapata.conf)
    ;
    ; This is not intended to be a complete zapata.conf. Rather, it is intended
    ; to be #include-d by /etc/zapata.conf that will include the global settings
    ;

    ; Span 1: TE2/0/1 "T2XXP (PCI) Card 0 Span 1" (MASTER)
    group=0,11
    context=from-pstn
    switchtype = euroisdn
    signalling = pri_cpe
    channel => 1-15,17-31
    group=
    context=default

    ; Span 2: TE2/0/2 "T2XXP (PCI) Card 0 Span 2"
    group=0,12
    context=from-pstn
    switchtype = euroisdn
    signalling = pri_net
    channel => 32-46,48-62
     
  2. just4fun

    Joined:
    Dec 8, 2008
    Messages:
    17
    Likes Received:
    0
    This mean that channel included in two groups 0 and 11
     
  3. jgutierrez

    Joined:
    Feb 28, 2008
    Messages:
    5,737
    Likes Received:
    0
    hi there,
    That means that trunks 1-15,17-31 are included on the group 0 and 11
    Also that trunks 32-46,48-62 are included on the group 0 and 12

    You may also customize these groups, I mean set a particular group of trunks into a specific group.

    for example if you have set up a group=1 on your zapata.conf file, you may create a trunk named g1, or r1.
    g1 will use the lines defined in that group, always starting from the lowest one up to the highest one

    r1 will use the lines defined in that group, in a round robin strategy, from the lowest one to the highest one, the diffrence is that you will sharing the load on your lines, while on the first case, you will be using almost everytime the same first lines
     

Share This Page