Card Digium TDM410P

Discussion in 'Gateways' started by rogelioArthas08, Aug 11, 2008.

  1. rogelioArthas08

    Joined:
    Jul 2, 2008
    Messages:
    16
    Likes Received:
    0
    Hi guys I need to configure digium car TDM410P for my elastix.
    I don't know too mucho how to configure this card. My elastix have detected my four ports from TDM410P but how can I use this card to make call outside for telephone convenctionals....
    I need to explain how to add a ZAP TRUNK, I think that there is the problem.

    So I need to know everething to configure and performance my elastix to make calls to my conventionals line of telephone..

    Thanks for all
     
  2. derbeder

    Joined:
    Jun 22, 2011
    Messages:
    16
    Likes Received:
    0
    hi , did u find any answer ?
    i have same issue.
    i have tdm 410p , 4 fxo port
    i created a zap chanel did , T1 cable connected to port 2.
    chanel : 2
    description : ttk_incoming
    DID : 500

    than , i created a inbound route with did number 500.

    but when i try to call from T1 , call didn't route my softphone. ( i set destiination to my sip user )

    thanks.
     

Share This Page