Can't route incoming calls properly -- SOLVED

Discussion in 'General' started by cblake, May 4, 2008.

  1. cblake

    Joined:
    May 3, 2008
    Messages:
    2
    Likes Received:
    0
    Hello All,

    I've just recently setup my first elastix server. I have configured a couple extensions that are able to communicate between each other. I have also managed to get it working with gizmo5 so I can receive and make calls to 'regular' phones.

    However, I have run into a problem when I'm trying to route incoming calls. If I set the incoming route to a specific extension, or the voice mail for a specific extension, things work fine. When I try to route the incoming calls to a ring group, announcement, IVR, etc, the incoming caller gets nothing but silence. I know the call comes in (the reports indicate that it's receiving the call), there's just nothing that the user can do, as soon as a button is hit, the call is terminated. The test call (7777) works as it should (ivr w/welcome message).

    The incoming route is "any DID / any CID".

    I'm running Elastix 1.0-17, FreePBX 2.3.1.5

    I don't know if it matters for this issue, but my trunk PEER details are:
    Code:
    allow=ulaw&alaw&ilbc&gsm
    authuser=1747xxxxxxx
    canreinvite=no
    context=from-pstn
    disallow=all
    dtmfmode=rfc2833
    fromdomain=proxy01.sipphone.com
    fromuser=1747xxxxxxx
    host=proxy01.sipphone.com
    insecure=very
    nat=yes
    qualify=yes
    secret=xxx
    type=friend
    username=1747xxxxxxx

    I'm fairly new to this, so I apologize if I miss anything. Thanks for the help!

    Post edited by: cblake, at: 2008/05/04 05:54

    Post edited by: cblake, at: 2008/05/04 05:55<br><br>Post edited by: cblake, at: 2008/05/05 07:50
     

Share This Page