can't install elastix 2.0.3

Discussion in 'General' started by doom, Dec 23, 2010.

  1. doom

    Joined:
    Dec 22, 2010
    Messages:
    2
    Likes Received:
    0
    Hi

    i've got a comp with: pentium 4, 1.5 GB ram and 60 GB hard disk

    i downloaded elastix 2.0.3 32 bit iso
    burned it to cd
    and when the boot start, i get all the setup running
    i decide the partitios, password, network
    and then when it start installing i get errors
    something about
    can't load from installtion tree,
    can't find repodata/primary.xml.gz.

    i checked that the iso is fine ( i installed it on a virtual pc)

    i can install on the computer ASTERISK NOW
    so i know the comp is ok

    what could be causing this ?
    is elastix has high requiremnts for my computer ?

    thanx
     
  2. Lee Sharp

    Joined:
    Sep 28, 2010
    Messages:
    332
    Likes Received:
    0
    A sucessfull install is not a definitive test of hardware. :) Run memtest86 on it for a few passes to make sure some high memory is not sending bad bits. Also, try the 2.0.2 iso as the 2.0.3 has some known issues.
     
  3. doom

    Joined:
    Dec 22, 2010
    Messages:
    2
    Likes Received:
    0
    i will try that

    thanx
     
  4. circuitid

    Joined:
    Dec 23, 2010
    Messages:
    15
    Likes Received:
    0
    You may also want to check the disc integrity of the CD that you burned to ensure that you had a successful burn. You can run an integrity check by typing in the following to the boot prompt of the Elastix installation CD:

    As Lee suggested, you can also run memtest from the Elastix installation CD to test the memory by typing:

    I hope this helps.
     

Share This Page