Can't install 1.5 with motherboar Intel D945GCLF

Discussion in 'General' started by fdiogo, Mar 28, 2009.

  1. fdiogo

    Joined:
    Sep 7, 2008
    Messages:
    52
    Likes Received:
    0
    Hi all!!

    I'm trying to install the new version of Elastix 1.5 but it always crash in section "Call Trace" the 2 last lines are:

    [<c055e219>] __driver_atach+0x0/0x6b
    [<c0540972>] bus_add_driver+0x64/0xfd

    and the scrool lock light and tha caps lock light on the ketboard starts blinking....

    in version 1.3 it i dont have any problems....

    i have tried install with "linux noprobe" it passes this section but then it does not detect the disk :-(

    Any ideas??

    thanks for your help!!!

    Diogo
     
  2. fdiogo

    Joined:
    Sep 7, 2008
    Messages:
    52
    Likes Received:
    0
    Hi again!!!

    it seems to be a network card problem.

    if i disable the network card on bios i can install...

    the network is a Realtek RTL8102EL i think!!!

    Diogo
     
  3. fdiogo

    Joined:
    Sep 7, 2008
    Messages:
    52
    Likes Received:
    0
    if you wont to install with this network card you have to install with the card disconnected or disable and then you have TO INSTALL FIRST the drivers and then you can connect or enable the card.

    it seems is working fine now....

    i leave here the solution for other having the same problem :)

    Thanks.

    Diogo
     
  4. Chilling_Silence

    Joined:
    Sep 23, 2008
    Messages:
    488
    Likes Received:
    0
    Thanks Diogo,

    I have a couple of the D945GCLF boards lying around that I use sometimes, but mostly I use the D945GCLF2 which is the dual-core, it has a different chipset which seems fine.

    Appreciate your time posting a fix

    Cheers


    Chill.
     

Share This Page