CallerID screening

Discussion in 'General' started by bittermike, Dec 22, 2009.

  1. bittermike

    Joined:
    Dec 9, 2009
    Messages:
    65
    Likes Received:
    0
    Hello and Happy Holidays to all,

    I am wondering if it is possible to screen the inbound callerID then send to some destination in my PBX.

    I created an inbound route with my cellphone callerID, then sent the call to my voicemail for a test but that did not work, the call just went to the any/all.

    I would like to do this mostly for known telemarketer numbers, I will create an IVR to put then in IVR hell ha ha ha...

    thank you all for your help and kindness!
     
  2. dicko

    Joined:
    Oct 24, 2008
    Messages:
    4,099
    Likes Received:
    0
    Inbound by CID works, make sure that the CID is exactly what the CLI shows, do the regex thing (wildcard) if needed.

    Explore the Blacklist and Superfecta/Lookup Sources thing for specifically denying "Unwanted or previously identified" idiots
     
  3. Patrick_elx

    Joined:
    Dec 14, 2008
    Messages:
    1,120
    Likes Received:
    0
    you can create an inbound route based on the CallerID number. Then you can route it the way you want.

    Just make sure that the DID is empty and that you enter the CallerID number the same way that it is presented by your trunk (have a look at the log to verify).
     
  4. voya

    Joined:
    Apr 6, 2009
    Messages:
    15
    Likes Received:
    0
    post cli log when you are calling the elastix.then we can help you much better.
     

Share This Page