call debug

Discussion in 'General' started by jmorrison, Nov 6, 2009.

  1. jmorrison

    Joined:
    Sep 23, 2009
    Messages:
    31
    Likes Received:
    0
    Hi Support,

    Can you give me the command to run that shows all active calls being made through the PBX.

    Also I have installed a Digium 8port card and having a little issue with one of the port. Is there also a command that can indicate which ports are good/defective.


    Also there are other commands that can be used for troubleshooting feel free to include as well.


    Regards
     
  2. dicko

    Joined:
    Oct 24, 2008
    Messages:
    4,099
    Likes Received:
    0
    rasterisk -x 'sip show channels'
    for sip calls
    rasterisk -x 'show channels'
    for all calls
    etc.

    Asterisk has "tab completion" whereby all possible commands are shown after a tab, From Asterisk CLI type help then tab , then help <add yuour word> and tab , keep going till you get what you want.
     
  3. jmorrison

    Joined:
    Sep 23, 2009
    Messages:
    31
    Likes Received:
    0
    Thanks for the advise
     

Share This Page