Broadcom NetXtreme II NIC/Elastix 64Bit Resolved

Discussion in 'General' started by mstopkey, Apr 28, 2009.

  1. mstopkey

    Joined:
    Mar 4, 2009
    Messages:
    26
    Likes Received:
    0
    Hello everyone. We were having issues trying to install the 64 Bit version of Elastix on our Dell 2950 servers and getting it to recognize the Broadcom ethernet devices. By buddy and Linux guru teacher came in and ran this command after 64 bit was installed. ifup eth0 Then the system loaded the device(s). Then I manually edited the file /etc/sysconfig/network-scripts/ifcfg-eth0. Below is the syntax for network.

    # Broadcom Corporation NetXtreme II BCM5708 Gigabit Ethernet
    DEVICE=eth0
    BOOTPROTO=none
    DHCPCLASS=
    HWADDR=00:00:00:00:00:00
    MTU=
    NETMASK=255.255.255.0
    IPADDR=192.168.2.2
    NETWORK=192.168.2.0
    GATEWAY=192.168.2.1
    ONBOOT=yes

    Thanks to Robert McClendon for this one.
     

Share This Page