B410P

Discussion in 'Gateways' started by sam, Aug 29, 2008.

  1. sam

    sam

    Joined:
    Aug 27, 2008
    Messages:
    16
    Likes Received:
    0
    Good morning,

    I am newbie.

    I have installed elastix latest version on my computer with a brand new b410p
    When I made lspci map b410p is in the list.

    I make my management elastix on another computer and, in detection equipment, impossible to find the B410P ... impossible to configure my telephone terminals.

    What do I do? I've jumped a step?

    Thank you for your help.
     
  2. DaveD

    Joined:
    Nov 12, 2007
    Messages:
    597
    Likes Received:
    0
    The B410P uses mISDN drivers which be default are not enabled in Elastix
    To enable at the console type setup
    menu presents
    select mISDN from menu to enable
    reboot and drivers should be enabled
     
  3. sam

    sam

    Joined:
    Aug 27, 2008
    Messages:
    16
    Likes Received:
    0
    Hello,

    I log root
    $ menu
    --> system service
    --> mISDN enable

    But nothing change after reboot...

    what's wrong ...

    Thanks a lot
     
  4. DaveD

    Joined:
    Nov 12, 2007
    Messages:
    597
    Likes Received:
    0
    mISDN is not linked to hardware detection at this stage in Elastix you need to configure the mISDN manually by editing the mISDN.conf files and then create your mISDN trunk to suit your needs.

    Edit
    What is the type of isdn connection you have from the telco, info will help others to help you
     
  5. sam

    sam

    Joined:
    Aug 27, 2008
    Messages:
    16
    Likes Received:
    0
    Hello,

    up to know, my isdn connection not plugged. I will use numeris from france telecom.
    I try to install misdn-queue from beronet but I get this:

    check 14 : error 1
    chan_misdn : Error 2

    and say that I need to recompile asterisk with misdn because I use asterisk>1.4
     
  6. khagelay

    Joined:
    Oct 30, 2008
    Messages:
    8
    Likes Received:
    0
    I am a newbie as well,

    I Have a new B410P.

    MIsdn is automatically startet, then

    1. misdn-init config
    2. Edit /etc/misdn-init.conf
    3. misdn-init start
    4. Edit misdn.conf

    I hope this is as far correct; Alas my card ist still not working

    What went wrong?
    2 Ports are TE and 2 ports NT mode (PTMP)

    What have I to do?
     
  7. sam

    sam

    Joined:
    Aug 27, 2008
    Messages:
    16
    Likes Received:
    0
    Well,

    install elastix and update it
    then install last zaptel (tar.gz on Digium site)
    "untar
    make
    make install
    make b410p"

    and after use
    misdn-init scan
    misdn-init config
    misdn-init start

    add it to your system boot:
    chkconfig --add misdn-init

    You should read "http://www.trixbox.org/forums/trixbox-forums/trunks/howto-install-script-digium-b410p" and everything will be ok.

    Ciao
     

Share This Page