We are fairly new to ISDN on Elasix and are attempting to install a Digium D410P We have followed several forum threads (most >9 months old) on previous test builds disabling DAHDI and using misdn. Unfortunatly we were unable to succesfully make a call. We have completed a fresh build of Ver1.6.2-7 and re-installed the card. we can see the card in hardware detection, span 1, 2, 3 are showing green, 4 is NT and showing red. (Though "Misdn Card" says "found no card" as we have not manually loaded misdn drivers yet) This really is the healthiest we have seen the card after all our attempts. Very Colourful. So my question is: should I attempt to configure this as misdn or continue with the DAHDI on this version of Elastix? 1.6.2-7.