Analog FXO - outbound works, inbound does not

Discussion in 'General' started by howwhi, Jun 15, 2009.

  1. howwhi

    Joined:
    Jun 11, 2009
    Messages:
    25
    Likes Received:
    0
    Elastix Without Tears is chopping onions on this topic ;)

    Thought I have the fiddly bit in freePBX unembedded to connect a DID to the channel but please admit the wording in this section is vague. Channel is an ambiguous term around these parts.

    In freePBX, I created a Zap Channel DID > channel 27, description local, DID 9873. In Elastix, I created an inbound route against 9873 to ring group 100. [Background info, system has a TE110P - channels 1-24 - and a TDM422B - channels 25-28]

    Hardware is working. Have analog phones connected to channels 25 and 26. Outbound route works on channel 27. Calling the same number gives the "this number is not in service" message. Here is a snip from the asterisk console:

    -- Starting simple switch on 'DAHDI/27-1'
    -- Executing [s@from-pstn:1] NoOp("DAHDI/27-1", "No DID or CID Match") in new stack
    -- Executing [s@from-pstn:2] Answer("DAHDI/27-1", "") in new stack
    -- Executing [s@from-pstn:3] Wait("DAHDI/27-1", "2") in new stack
    -- Executing [s@from-pstn:4] Playback("DAHDI/27-1", "ss-noservice") in new stack
    -- <DAHDI/27-1> Playing 'ss-noservice' (language 'en')
    -- Executing [s@from-pstn:5] SayAlpha("DAHDI/27-1", "") in new stack
    -- Executing [s@from-pstn:6] Hangup("DAHDI/27-1", "") in new stack
    == Spawn extension (from-pstn, s, 6) exited non-zero on 'DAHDI/27-1'
    -- Executing [h@from-pstn:1] Hangup("DAHDI/27-1", "") in new stack
    == Spawn extension (from-pstn, h, 1) exited non-zero on 'DAHDI/27-1'
    -- Hungup 'DAHDI/27-1'

    Sorry to impose on the valuable resources. I have looked for quite a while for an answer to a common problem but I find no answers for an analog channel. Lots of SIP systems with a similar problem...
     
  2. howwhi

    Joined:
    Jun 11, 2009
    Messages:
    25
    Likes Received:
    0
  3. mahpayma

    Joined:
    Sep 24, 2010
    Messages:
    27
    Likes Received:
    0
    Hi,
    the link you mention is not a working, can you please explain a little bit.
     

Share This Page