adding a second Rhino RCB4FXO

Discussion in 'Gateways' started by ashley_dew, Aug 1, 2008.

  1. ashley_dew

    Joined:
    Aug 1, 2008
    Messages:
    1
    Likes Received:
    0
    Hi,

    My ipbx is working fine, with one rhino R4FXO-EC but when I install the second card after some time kernel crash.

    The second card is ok, since I tested on standalone.

    My question is the configuration ok:

    zaptel.conf


    # Span 1: Rhino RCB4FXO/1 "Rhino RCB4FXO/1"
    fxsks=1
    fxsks=2
    fxsks=3
    fxsks=4
    # Span 2: Rhino RCB4FXO/2 "Rhino RCB4FXO/2"
    fxsks=5
    fxsks=6
    fxsks=7
    fxsks=8

    zapata.conf

    ; Span 1: Rhino RCB4FXO/1 "Rhino RCB4FXO/1"
    signalling=fxs_ks
    ; Note: this is a trunk. Create a ZAP trunk in AMP for Channel 1
    context=from-pstn
    group=0
    channel => 1-8

    zapata-auto.conf


    ; Span 1: Rhino RCB4FXO/1 "Rhino RCB4FXO/1"
    signalling=fxs_ks
    ; Note: this is a trunk. Create a ZAP trunk in AMP for Channel 1
    context=from-pstn
    group=0
    channel => 1-8




    Is the configuration right, or should I break them channel => 1-4 for span 1
    channel => 5-8

    I am not using genzaptelconf but configuring it manually so.


    Thanks,


    Ashley
     

Share This Page