Recent content by salazarw

  1. Trying to set Elastix channel bank PRI to T1

    The solution to the problem turned out to be very simple. To those people using an Elastix or any other Xorcom channel bank DO NOT look for a switch on the hardware to change from E1 to T1. This is all done through software. If you run into the same problem I had where the xpp.conf file...
  2. Trying to set Elastix channel bank PRI to T1

    I
  3. Trying to set channel bank PRI to T1

    I
  4. Backup/Restore with FTP option

    Does anyone know if the new backup/restore module available on Elastix 2.0 can be added to Elastix 1.6? If this is possible pleas provide the steps?
  5. Route a call to two different lines simultaneously

    In my example phone B is one of the executive
  6. Route a call to two different lines simultaneously

    I have two Polycom phones registered with two different extensions. Phone A has three line appearance for extension 8105 and one appearance of extension 8100. Phone B has three line appearances on extension 8100. Calls are only routing to phone A. How do I make calls route two both phones...
  7. Elastix 1.6 Network Configuration not available

    I have successfully installed the network configuration component. Thank you Diko.
  8. Elastix 1.6 Network Configuration not available

    I just installed Elastix 1.6; ran
  9. Follow Me portal for end user

    Hi Ramon, Thank you for sharing instructions to addess my problem. Works great. Thank you again.
  10. Follow Me portal for end user

    I
  11. Digium TDM422BF analog card

    Hi Dicko, I can see the board after I re-installed the DAHDI drivers as per your suggestion. Now I
  12. Digium TDM422BF analog card

    I will give that a try..
  13. Digium TDM422BF analog card

    I installed the Zaptel drivers after the board could not recognized by Elastix. I followed instructions on an Asterisk book I purchased calling for Zaptel drivers. I did not know that the board would work with DAHDI. However, the DAHDI drivers are installed. Is there a conflict between the...
  14. Digium TDM422BF analog card

    I installed a new Digium TDM422BF card on HP Proliant server running Elastix 1.5.2. I ran the
Top