bar top left
bar top right
left curve
right curve
Welcome, Guest
Forgot your Password? Forgot your Username? Create Account
Elastix Forums :: Open Source Unified Communications Server
Elastix
Newbie's Corner

Elastix 2.0.0-36 with D110P on T1 line
(1 viewing) (1) Guest
Go to bottom
Post Reply
Post New Topic
Page: 1
TOPIC: Elastix 2.0.0-36 with D110P on T1 line
#58950
Elastix 2.0.0-36 with D110P on T1 line 1 Year, 5 Months ago Karma: 0

Hi ALL,

I"m a newbie in Asterisk, and just came across a stupid question.
I had just purchased a D110P to be used with my Elastix on T1 line. I have followed the instructions to download the dahdi-linux tools, but after MAKE, error come out.


>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
"DAHDI_ATTACH_ECHOCAN failed on channel 1: Invalid argument
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>


and after that, the card LED light no longer blink red or stay green. I have no idea, but instead re-install the Elastix, the card Green light is back, and I can check by 'dahdi show status & dahdi show channels' that the card itself seems working.


I have set inbound (Any DID/CID), outbound (_9) and with default zap/g0 trunk. But I cannot successfully dial out any call, only show "ALL CIRCUITS ARE BUSY NOW", and no inbound call.


Can any brothers suggest me what should be my next step? I'm sorry for my low-end question, but I really hope to get help.


Tks!


Right now, I'm sorry that, I don't know what's my next step. Since, I cannot get my system working, no Inbound
Enter code here   
Please note: although no board code and smiley buttons are shown, they are still usable.
magmag
Fresh Boarder
Posts: 7
graphgraph
User Offline Click here to see the profile of this user
Reply Quote
 
#59039
Re:Elastix 2.0.0-36 with D110P on T1 line 1 Year, 5 Months ago Karma: 3
You most likely still need to configure the card for T1 CAS or PRI in:

/etc/dahdi/system.conf

Once you get the card configured, you then need to set the card up in asterisk using:

/etc/asterisk/chan_dahdi.conf

Not sure what kind T1 circuit you have, but there's a variety of setting in this config, so most likely it will be trial and error. Read the /etc/dahdi/system.conf for options.
Enter code here   
Please note: although no board code and smiley buttons are shown, they are still usable.
gl1176
Junior Boarder
Posts: 55
graphgraph
User Offline Click here to see the profile of this user
Reply Quote
 
Go to top
Post Reply
Post New Topic
Page: 1
Elastix Forums :: Open Source Unified Communications Server
Elastix
Newbie's Corner
Moderators: rafael, Bob, jgutierrez
Powered by Kunena | KunenaSpanishget the latest posts directly to your desktop

Copyright © 2006 - 2011 Palosanto Solutions. All Rights Reserved.

Banner